This custom-cut, durable 3ml mylar protects the area from the standups at the entrance to the inline drops all the way to the base of the cross, giving your playfield a fighting chance to resist the target cutouts chipping from repetitive hits. A single-use alcohol wipe is included to prepare the surface for mylar installation.
NOTE: If you ALREADY have chipping present, you MUST use clear nail polish like Sally Hansen's Hard as Nails plain, clear nail polish to arrest the chip(s) and then let that dry before putting this mylar on, or the chipping will just continue spreading under the mylar.
INSTALLATION INSTRUCTIONS:
- This is much easier if you unmount the two targets at the front of the inline targets and drop the target bank down, so I recommend doing that.
- Peel the backing from the mylar at the end with the big circular hole for the magnet about 1/2" and fold it back sharply, exposing the mylar.
- Line the straight edge of the exposed mylar with the straight edge of the playfield in front of the cross and tap it gently to just barely let it stick, then lay the rest of the mylar with the adhesive in place to make sure you have the alignment correct (all the holes line up with no overlap/short on the holes. If it's right, they all should be almost perfectly centered for all the holes almost right to th edge of each playfield cutout.
- If it DOES NOT line up, pull the piece that's stuck, and try again with the small exposed piece at the cross to get the alignment correct.
- Once you have verified the alignment is right, lift the mylar enough to get a hold on the 1/2" piece of backing and slowly pull on that with one hand while you use a finger on the other hand to sweep across the mylar, back and forth across the width of the mylar so it lays down correctly and does not have air bubbles in it.
- Continue sweeping with your finger and pulling the backing until you have the backing removed and the mylar completely laid down. You can use the edge of a credit card to press the mylar onto the playfield even more securely.
- Re-install targets, inline drops, and trim plastic. Enjoy!