Walking Dead Remaster Magnet Mylar set

Reinforce the playfield edges around both magnets from to help resist chipping.  Includes a mylar ring for each magnet and ONE alcohol wipe for playfield area before application. The same single use alcohol wipe is shown in both pictures for illustration purposes only. 

NOTE: If your playfield has already chipped or flaked in the area you intend to install the mylar, you MUST clean and then seal the chip/flake area with Sally Hansen's Hard as Nails clear nail polish #800 (UPC 0 74170 38283 9) to arrest the chipping. If you just put the mylar over the damage without taking this step, the chipping can continue under the mylar.

INSTALLATION TIPS:

1. Grab a credit card or other plastic card like a store loyalty card. You'll need the hard edge to smooth the mylar. 
2. Use the included alcohol wipe to make sure the area around the magnet pad where the mylar will go.  Let it dry.
3. Test fit the mylar with the paper backing still on it so you can see how it should line up, centering it on the magnet pad.
4. Bend back about 1/2 of the backing paper on the bottom edge and crease it hard so it sets as flat as possible against the back side. 
5. The exposed sticky part of the mylar should hover slightly above the playfield from the fold thickness, allowing you to test alignment first using the target slot as a visual alignment point. You want the center hole in the mylar centered over the magnet pad on the playfield.
6. Line up the mylar so it looks like the white paper-backing image on this page that shows the fit.  Once you get it lined up, press the sticky part to the playfield and smooth it with your finger.
7. Double check that the rest of the still-papered mylar is lining up and the mylar is still centered over the magnet pad.  If it ISN'T, pull up the sticky stub and do step 5 again.  If it IS still lined up, continue to step 8.
8. Lift the mylar and grab the remaining 1/2 of the paper you folded back underneath and slowly pull it from the back as you smooth it with your finger left and right to make sure no bubbles get under the mylar. Pull and smooth slowly for a good install.  
9. Once it's all laid down, smooth the mylar more with the credit card edge left to right in small motions until the mylar seems to disappear into the playfield.
10. That's it! You're done!