Walking Dead Remastered Woodbury Mylar

This mylar piece protects the area in front of and behind the drop target at the Woodbury shot.  Photo shows the clear mylar with the white backing paper still attached for visibility.  When the paper is removed the mylar is transparent.  Alcohol wipe to prep the playfield included.

NOTE: If your playfield has already chipped or flaked in the area you intend to install the mylar, you MUST clean and then seal the chip/flake area with Sally Hansen's Hard as Nails clear nail polish #800 (UPC 0 74170 38283 9) to arrest the chipping. If you just put the mylar over the damage without taking this step, the chipping can continue under the mylar.

INSTALLATION TIPS:

1. Grab a credit card or other plastic card like a store loyalty card. You'll need the hard edge to smooth the mylar. Note that if you remove the spinner, it will make this install easier, but it's not required.
2. Use the included alcohol wipe to make sure the area where the mylar will go.  Let it dry.
3. Test fit the mylar with the paper backing still on it so you can see how it should line up outlining the target cutout and the indentation for the wire guide on the right side.
4. Bend back about 1/2" of the backing paper on the bottom edge and crease it hard so it sets as flat as possible against the back side. 
5. The exposed sticky part of the mylar should hover slightly above the playfield from the fold thickness, allowing you to test alignment first using the target slot as a visual alignment point. You want the target cutout centered in the mylar cutout.
6. Line up the mylar so it looks like the white paper-backing image on this page that show the fit.  Once you get it lined up, press the sticky part to the playfield and smooth it with your finger.
7. Double check that the rest of the still papered mylar is lining up.  If it ISN'T, pull up the sticky stub and do step 5 again.  If it IS still lined up, continue to step 8.
8. Lift the mylar and grab the 1/2" you folded back underneath and slowly pull it from the back as you smooth it with your finger left and right to make sure no bubbles get under the mylar. Pull and smooth slowly for a good install.  
9. Once it's all laid down, smooth the mylar more with the credit card edge left to right in small motions (the clearance is tight so you can't really do long strokes) until the mylar seems to disappear into the playfield.
10. That's it! You're done!